WHEELTRONIC SPACESAVER 9000 Series, Инструкция по установке и эксплуатации

Страница: 13 / 31

13 of 31
5. Slot in end of the bar should be parallel to the ground when center cut-out points up
towards the front. Refer to Figure 4 .
Figure 4. Safety release rod location
6.
Install the rectangular safety release tab using 2; ¼" - 20UNC x ¾" long hex bolts and
lock washers. The safety release tab bolts to the flat surface of the safety release rod
located under the mechanical safety locking bar.
7.
Install foot pedals one on the outside of each safety release rod, using for each pedal 2;
¼" - 20UNC x 1¼" long hex bolts, nuts, and lock washers.
8.
Install pedal safety guards. One on each baseframe using the ¼" - 20UNC x ¾" long hex
bolts, nuts, and lock washers.
9.
Install the safety release connecting rod between the safety release rods, using
¼" - 20 UNC x 1 ¼" long hex bolt, nut and lock washers one on each end of the rod.
10.
Tighten all installation hardware.
11.
Place the mechanical safety locking bars back in their engaging positions.
Turn power back on.
12. FOR THOSE UNITS EQUIPPED WITH SLIDING JACK BEAMS NOW IS THE
TIME TO INSTALL THE JACK . Lower lift and consult instructions supplied with each
Jacking Beam.
13. Turn on the shop air supply and check for leaks. The air supply line should have an
operating pressure of 90-120psi (6-8bar).