WHEELTRONIC SPACESAVER 9000 Series, Инструкция по установке и эксплуатации

Страница: 11 / 31

11 of 31
NOTE: When working with hydraulics it is important to keep all components clean. All
hydraulic connections are 37 ½° JIC flares.
1.
Select a position best suited for the power pack.
2. Remove the breather filler cap and fill with 20liters/5.3Gal. of ISO 32 hydraulic fluid.
3.
Using a hydraulic tube bender, run a hydraulic line from the power pack to the hydraulic
inlet fitting located on the left side of the left base frame. After all the lines are cut and
formed, install the nuts and sleeves, and then flare the ends of the tube.
4.
If you have purchased the factory air kit option you should now cut and form the air supply
line, from the lift to the desired location for customer connection to their shop air supply.
The air supply line should have an operating pressure of 90-120psi (6-8 bar).
5. Tighten all the supply lines. You may now anchor the hydraulic power pack. (floor or
wall
mount).
6.
Connect one end of the center hydraulic line to the outlet side of the left main frame
assembly and the other end to the inlet side of the right main frame assembly. Tighten
the hydraulic line in place so that it runs along the floor giving it a low profile.
IMPORTANT: THE SHIPPING CLAMPS HOLDING EACH MAIN FRAME ASSEMBLY
TOGETHER MUST BE UNBOLTED BEFORE CONNECTING ELECTRICAL POWER.
THERE ARE TWO (2) CLAMPS ON EACH ASSEMBLY.
6.4 ELECTRICAL
INSTALLATION
IMPORTANT: ALL FINAL ELECTRICAL CONNECTIONS SHOULD BE
MADE BY A QUALIFIED ELECTRICIAN .
Please refer to Figure 3 , the electrical diagram. Select a position for the remote hand
control pendant to be hung from the ceiling. Hang in a position so the safety pedal may
be easily reached.
NOTE: THE CONTROL PENDANT SHALL BE INSTALLED IN SUCH A
MANNER THAT THE CONTROL PENDANT CANNOT ENTER THE 18” HIGH
LEVEL ABOVE THE FLOOR.
(CLASS 1, DIVISION 2, HAZARDOUS LOCATIONS)