Wheatstone E-SAT, Техническое руководство

Страница: 54 / 126

page 2 – 20
E-Series Network / Apr 2007
H A R D W A R E
Software Programming
For details on programming the LIO-NC4, please refer to “Configuring Logic
I/O” in the XPoint Software Setup Guide later in this manual.
Internal Programming Options
All internal programming options are made via PCB mounted dipswitches
and jumpers.
Dipswitch / Jumper Settings
DIPSW1 -SW3 - Logic In/Out Settings
SW1 position 1 sets logic port 1 as logic input when ON or logic output when OFF.
SW1 position 2 sets logic port 2 as logic input when ON or logic output when OFF.
SW1 position 3 sets logic port 3 as logic input when ON or logic output when OFF.
SW1 position 4 sets logic port 4 as logic input when ON or logic output when OFF.
SW2 position 1 sets logic port 5 as logic input when ON or logic output when OFF.
SW2 position 2 sets logic port 6 as logic input when ON or logic output when OFF.
SW2 position 3 sets logic port 7 as logic input when ON or logic output when OFF.
SW2 position 4 sets logic port 8 as logic input when ON or logic output when OFF.
SW3 position 1 sets logic port 9 as logic input when ON or logic output when OFF.
SW3 position 2 sets logic port 10 as logic input when ON or logic output when OFF.
SW3 position 3 sets logic port 11 as logic input when ON or logic output when OFF.
SW3 position 4 sets logic port 12 as logic input when ON or logic output when OFF.
J3 - AGND to DGND - default is “CLOSED”
J3 connects Audio Ground to Digital Ground.
Hook-Ups
All user wiring from the LIO-NC4 card takes place at the female DB-25
connector on the cage rear.
Logic Connections
These include 12 input/output sources. Pinout drawing on page 2-22 shows
all wiring connections at a glance.
Pin 12 – Logic 1 In/Out +
Pin 25 – Logic 1 In/Out -
Pin 11 – Logic 2 In/Out +
Pin 24 – Logic 2 In/Out -
Pin 10 – Logic 3 In/Out +
Pin 23 – Logic 3 In/Out -
Pin 9 – Logic 4 In/Out +
Pin 22 – Logic 4 In/Out -