Wheatstone Corporation G-3, Техническое руководство, Страница: 23 / 66

C O N T R O L P A N E L
page 3 – 5
G-3 / Jun 2004
MXM Talkback
To interrupt a signal with the TB signal, press any
of the four MIX-MINUS/TALKBACK momentary
switches.
Timer Section
The digital timer display is mounted in the righthand
end of the control surface’s meterbridge, and it’s con-
trol buttons are in the center of the EFS panel.
The control surface timer is provided with an AUTO-
RESTART function so programmed (via GUI) input
modules can automatically reset the timer display to
zero and start a new count (if the timer is currently
running), allowing the announcer to easily track his
own pace.
The START/STOP button halts the timer, holds the
last count, and then restarts and accumulates the count
when depressed again
—
perfect for compiling tapes of
desired duration.
RESET has a dual-mode capability:
- if you depress it while the timer is counting, the display will
instantly reset to zero and start a fresh count;
- if the timer is already stopped, depressing this button will reset the
timer to zero, where it will hold until start is pressed.
The HOLD button allows you to hold the display for a longer
viewing duration, while still allowing the counter to continue in the
background. Releasing the button will then display the current count.
Control Modes
The G-3 control surface is op-
erated in one of three modes. In
Administrator mode access is al-
lowed to all surface functions. In
User mode a limited set of user
functions is allowed. The set of
functions allowed in User mode is set independently for each console
using the Bridge XPoint software (see the Bridge Router manual for
details). The third mode, Guest, blocks out MXM level, MXM assign,
Event takes, and visibility changes from being controlled by the
surface.
To change the control mode, begin by pressing and holding the
SOURCE SELECT knob until the display reads “Admin” and the
TAKE button lights (if the surface is currently in Admin mode the SET
button will also light). Turn SOURCE SELECT until the desired new
mode (Admin, User, or Guest) is showing in the display and press
TAKE. Turn SOURCE SELECT again to select the first digit of the
G-3 / Aug 2004