Wexiodisk WD-6, Инструкция по установке и эксплуатации

Страница: 15 / 60

Glass
tilt Rev. 2.0 (202202)
Installation instructions
11
3.4 Installation
3.4.1 Preparing for the installation
Check that there is sufficient room for the machine at the installation location.
• Check that correct connections are available for water, electricity, drainage
and possibly steam at the installation location. See TECHNICAL
SPECIFICATIONS.
• Check that the overheating protection device is reset.
3.4.2 Positioning the machine
Check the following points before the machine is placed in position:
• Check that the fuse for the machine at the site is off, blocked and that
outgoing electrical circuits from the machine are non-live.
• Remove the protective plastic on the sides which are to be stood against a
wall.
• The distance between the wall and machine should be at least 20 mm.
• If the machine is to be corner-loaded, it must be positioned with the control
panel furthest away from the wall.
Place the machine in position and check that it, and any accessories, are
horizontally level. Adjust the height with the legs.
Check with a spirit level that is standing level. Place the spirit level on the join
between the machine tank and the upper part. Once the machine has been filled
with water, do another check to make sure the machine is horizontal.
Check using a spirit level that the machine is standing level
6,7_Inst_plac