18
Operation
Motion Controlled Operation
1.
You can adjust the motion sensor (1) horizontally and
vertically. For vertical adjustment, unscrew the locking
screw (12) at the joint of the motion sensor and hand
tighten the screw after adjusting it.
2.
To adjust the motion sensor horizontally, grasp the
whole sensor and turn it very carefully to the left or to
the right to the desired direction.
Adjustments
There are three adjusting knobs on the
motion sensor: SENS, TIME and LUX.
1.
With the SENS knob (9) the sensitivity of the motion
sensor for motions can be set.
2.
Use the TIME knob (10) to setup the illumination time of
the unit after motion stops in the field of vision. The time
can be set from 10±5 seconds to 10±1 minutes. Please
note, once the light has been triggered by the sensor
any subsequent detection will start the timed period
again from the beginning.
3.
The LED floodlight has a built-in sensing device (photo-
cell) that detects daylight and darkness. Turn the LUX
knob (11) towards ( ) to have the motion sensor turning
on the light in brighter illumination conditions, turn it to
(
) to have the light activated only in darkness.
4.
The LED floodlight automatically switches on each time
the motion sensor (1) detects motion within its field of
view. The light will turn off after the set time when no
more motion is detected.
