3
6. SAFETY PRECAUTIONS (CONT)
7. INSTALLATION
ON/OFF
SWITCH
POWER
SOCKET
This Westlab Smart Micro Centrifuge is supplied in a
packaging box. Open the box, gently remove the
centrifuge from the box and plug in the power adaptor
pin before connecting to the main power source. The
instruction manual and the accessories should be kept
with the centrifuge. Please keep all packaging in safe
storage for at least 2 years for warranty purposes.
Make sure the rotor is tight to avoid any accidents. Load
the rotor with the micro tubes forcentrifugation. Place
theON/OFFswitchto“o”, rear,set the desired speed and
time, and close the lid to start centrifugation.
For more clarification refer to the RCF chart below:-
• Make sure to always use only specified micro
centrifuge tubes made from plastic and designed
to withstand centrifugal forces of at least 2000 g.
• Do not operate the centrifuge without the rotor being
properly attached to the shaft. Re-check by trying to
pull it up manually, especially after the rotor has been
changed or re-assembled.
• Do not move the centrifuge while it’s under operation.
• Do not fill the tubes while they are in the rotor. Liquid
spillage may harm the unit.
• Do not put hands in the rotor chamber unless the
rotor has completely stopped.
• Do not centrifuge flammable, explosive or corrosive
materials.
• Do not use solvents or flammable media near this or
other electrical equipment.
• In case the unit is dropped from the table, please
check the casing for any cracks/damage.
• The centrifuge and its components are
non autoclavable.
• Do not use the centrifuge in any manner not specified
in these instructions.
WESTLAB
SMART MICRO
CENTRIFUGE
USER MANUAL
CODE 663-958
C
