Westinghouse WFE914SB, Руководство пользователя

Страница: 35 / 48

35
INSTALLATION OF THE APPLIANCE
INSTALLATION OF THE APPLIANCE
Gas model clearance requirements
Models WFE914SB AND WFEP915SB
• Ensure the appliance is installed in accordance with
clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1 or clauses
6.9.1 and 6.9.5 of AS/NZS 5601.2 with regard to
clearances to combustible surfaces and materials,
and clearances to rangehoods and exhaust fans,
to ensure clearances of 200mm from burners to
vertical combustible surfaces observe the minimum
dimension of 100mm from each side of the cooker
to combustible surfaces.
• Clearances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
with clause 6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2
of AS/NZS 5601.2.
• When setting the cooker height, ensure the top of
the cooker is at least 10mm higher than the level
of the benchtop.
Dimensions
Gas hob 910mm
(adjustable 910 - 930mm)
Ceramic hob 906mm
(adjustable 906 - 926mm)
600mm
895mm
60mm
15mm (height of
trivet above hob)
installing splashback (Models with hob only)
Fit splashback to rear of hob with three screws provided.
Cabinet requirements
Models WFE914SB, WFEP915SB, & WFE946SB are
designed to fit into a 900mm wide gap between
standard kitchen cabinets. The appliance integrates with
the kitchen cabinets by matching the height, depth and
kick panel. The cooker may also be installed at the end
of a line of benches or with a free space either side. In
addition, a slot-in type installation is catered for allowing
a continuous cabinetry kick panel to be used. Model
WVE916 is designed to be built into cabinetry either
below a benchtop or into a vertical cabinet.
WARNING
WARNING
• The cooker must be installed and serviced only by
an authorised person.
• A Certificate of Compliance MUST be supplied to be
kept by the customer.
• The packing materials must be removed before you
install the cooker.
• The surrounding kitchen cabinets must be able
to withstand 85°C. Electrolux WILL NOT accept
responsibility for damage caused by installation into
kitchen cabinets which cannot withstand 85°C.
• The pipes used for installation MUST have sufficient
loops so the cooker can be moved for service (gas
models).
• The vents, openings and air spaces MUST NOT be
blocked.
• The anti-tilt brackets and chain or front stops MUST
be installed to avoid accidental tipping (freestanding
and slot-in models).
• You MUST NOT lift or pull the cooker by the
door handle.
• The cooker MUST be checked every five years.
• If the supply cord is damaged,it must be replaced
by the manufacturer,its service agent or similarly
qualified persons in order to avoid a hazard.
• The appliance must not be installed behind a
decorative door in order to avoid overheating.