33
TROUBLESHOOTING
Faults
If there is a problem with the oven and/or grill, please:
• Check the points listed below before calling for
service. It may be possible to avoid a call by fixing
the problem yourself – and so continue cooking.
PROBLEM
POSSIBLE CAUSE
WHAT TO DO
Oven or grill not working
Power not turned on
Switch on electricity
Household fuse blown
Check fuses
Controls incorrectly set
Reset controls
Circuit breaker tripped
Check circuit breaker
Clock not set
Set time of day on timer
Demo Mode ‘ON’ (for WFE946, WVE916,
WVEP916 & WFEP915)
Deactivate DEMO Mode. Refer to ‘Using
your oven’
Child Lock ‘ON’ (for WFE946 & WFE916)
Deactivate Child Lock. Refer to ‘Using
your oven’
Oven not heating enough
Foil or trays on bottom of oven
Remove foil or trays
Light & fans on continuously Timer not in manual mode
Set timer to manual mode
Oven not working
Timer not in manual mode
Set timer to manual mode
Household fuse blown
Check fuses
Oven light not working
Household fuse blown
Check fuses
Circuit breaker tripped
Check circuit breaker
Lamp blown or loose in socket
Replace or tighten lamp
Cooker smoking when first
used
Protective oils being removed
Turn grill on high for 30 mins and then
the oven on 220°C for 1 hour
Too much condensation
building up when baking
Too much water used when cooking
Reduce amount of water
Leave oven door open after cooking
Smells when first using oven
Protective oils being removed
This is normal
Timer flashing
Power failure or interruption
Reset time of day
Burner will not light even
though the sparker is
working
Knob not held down long enough in ‘High’
position for flame safeguard (where fitted)
to engage
Repeat lighting procedure and hold
knob down for 5 seconds in ‘High‘
position
Gas supply valve turned off
Turn on gas supply to appliance
Wrong knob turned off
Ensure the knob you are turning
corresponds to the burner you wish to
light
Port blockage in ignition area
Ensure the ports in the ignition area are
clean and dry
Ignition spark plugs wet or dirty
Dry or clean ignition spark plugs
No spark is obtained when
control knob is activated
Electricity supply is disconnected or
switched off
Switch on electricity or check fuses
Ignition spark plugs wet or dirty
Dry or clean ignition spark plugs
Flames uneven or tending
to lift
Flame ports blocked or wet
Clean or dry flame ports
Burner incorrectly fitted
Ensure this component is fitted
correctly
TROUBLESHOOTING
NOTE: Only authorised personnel should carry out servicing. If the household fuse continues to blow, call the Customer Care Centre. In the
event of a power failure the gas burners may be lit with a hand held igniter and used. Take care to avoid letting unburnt gas flow for more
than 5 seconds when attempting to light the burner.
NOTE: We may charge for service even in the guarantee
period if your problem is due to the causes listed below.
Содержание WFE914SB
Страница 46: ...46 NOTES NOTES ...