Westfield XTR2, Руководство по монтажу

Страница: 155 / 159

2.3
Step 2 ; Seat Frame Mountings
Assemble the two seat mounting frames using the 18 M6 x 20 button head screws and then bolt to
the adjustable seat runners using the M8 x 20 cap screws and nuts. Then locate in the front two
mounting holes in the chassis and mark the position of the two rear holes. Then just remove frame
from the chassis and drill the 4 holes 8mm. Replace the seat frames and bolt in position.
NOTE; It is advisable to fit the seat frames to the chassis before final fitting of the bodywork.
Also do not fit the seats to the frames until the bodywork is in position.
This Chassis Strap is
the one you need to
Drill the Rear Mounting
Holes Through.
Assembled Seat Frame
in Chassis. On
Adjustable Runners
Step 3; Tunnel Protection and Gaiter Set
NOTE; These items must be fitted prior to an SVA test.
Two vinyl covered tunnel protectors are provided and need to be fixed to the top of the tunnel in
front and behind the gear lever. They can be fixed on with either Velcro, pop rivets or rivnuts and
button head screws. The two gaiters provided one for the gear lever and one for the handbrake
must be retained with Velcro or rivets.
There are also two under scuttle pads (vinyl covered) that fit under the dashboard area which are
required for SVA. The near side one needs to be removable so that you can access the fuses if
necessary.