Westfield XTR2, Руководство по монтажу

Страница: 136 / 159

2.9
1.k. Pedal Box Cover
Place the cover into the recess on
the main body section and drill
two 5mm pilot holes through
both surfaces. Then remove the
cover and drill and rivnut the
underneath flange.
1.l. Reverse Lever and Button Holes
Measure as accurately as
possible the position of your
reverse lever in the cockpit and
the open up a slot for it to
operate in. Then position a
12mm hole correctly so that
you can push the button whilst
you are operating the lever
forwards.
NOTE: This Picture is of a Left Hand Drive Car
1.m Engine Cover
The engine cover will already have a pre-trimmed hole which will go over the engineand
air filter. Place the cover onto the main body section and check you have enough
clearance around this area and also round the two rear roll over bar stays. All that is left
then is to line up the air intake scoop with this profile and drill about eight 5mm holes
around the flange and engine cover to bolt the two parts together.