Westfalia OSD 6-91-067, Инструкция по эксплуатации

Страница: 155 / 206

Westfalia Separator
Mineraloil Systems GmbH
155
2058-9001-101 / 0506
4.8 Final checks after assembling the separator
Before starting the separator
Perform the following checks after assembling and before starting the separator
depending on the scope of the repair work:
Checks
Section
1. Bowl height 4.7.1
2 . Oil level in drive chamber 4.2.3
3. Direction of rotation of the bowl 4.1.4
4. Bowl speed 4.1.5
5 . Starting time of bowl / current consumption 4.1.5
6. Running characteristics of the separator 3.8.1
7. Suction line of the product pump (if installed) for leakage
When starting the separator
Perform the following checks after carrying out repairs:
Checks
Section
1. Temperature of product
2. Observe discharges for water, solids and oil to see if the
bowl is operating correctly.
3.3
4.9 Before a long-term shut-down of the separator
•
Thoroughly clean the separator (see sect. 4.3.2 and 4.3.3).
•
Dry and grease the clean bowl parts and all unvarnished machine parts to
avoid corrosion damage.
•
Store the clean, greased bowl in a dry place until reuse.
•
Store the gaskets in a cool, dry, dust-free dark room to prevent them from be-
coming brittle.
•
Take off the drive belt.
•
Check if the shut-off valves for water leak.
•
If necessary, disconnect the water lines to prevent damage by dripping water.
Preserving the separator:
•
Drain the lube oil.
•
Fill the drive chamber with a slushing oil, e.g. Shell oil S.7294 (SAE 30/SAE
50), to the middle of the sight glass.
•
Let the separator run without bowl for approx. 1 minute to make sure that all
drive parts are coated with slushing oil.