Lit. No. 28270, Rev. 00
July 1, 2005
27
Scoop/Vee Blade Position
The two round buttons located to the
left and right of the RAISE button
move both wings at the same time
into the following blade positions:
NOTE: Blade wings may not move
at the same speed.
Wing Positions
The two round buttons located to the
left and right of the LOWER button
move either wing independently of
the other as described below.
Function
Description of Operation
SCOOP
Press this button to extend both wings forward into the scoop position.
Function times out after 5.5 seconds.
VEE
Press this button to retract both wings into the vee position. Function times
out after 5.5 seconds.
Function
Description of Operation
L WING
Press the round WING button on the left side of the control to move the left
wing. The first time the button is pressed after the control is turned on or
another function is used, the wing will extend. Repeated use of the same
button, without using another function, results in movement in the opposite
direction from the previous movement. Function times out after 5.5 seconds.
R WING
Press the round WING button on the right side of the control to move the
right wing. The first time the button is pressed after the control is turned on or
another function is used, the wing will extend. Repeated use of the same
button, without using another function, results in movement in the opposite
direction from the previous movement. Function times out after 5.5 seconds.
Control Functions
Raise, Lower, Float, Angle
The four diamond-shaped buttons in
the center of the control face, when
pressed, will result in the following
blade movements:
Function Description
of
Operation
RAISE
Press this button to raise the snowplow and cancel the float mode.
Function times out after 3.0 seconds.
LOWER
Press this button to lower the snowplow. Release the button to stop blade
at desired height.
FLOAT
Press the
LOWER
button and hold 3/4 second to activate this mode. The
FLOAT
indicator light in the upper left corner of the control face will
illuminate. The blade will lower to the ground surface and follow the
contour of the surface as it dips or raises. Function does not time out, but
control will shut down after 20 minutes of nonuse.
Press
RAISE
button momentarily to cancel float. Angling left or right will
interrupt (stop) the float function while the blade angles, but will return to
float when angling is complete.
L
– Angle
Left
With wings in a straight line, press the
L
button to move both wings to
the angle left position to cast snow to the driver's left side. The left wing
retracts while the right wing extends. Function times out after 5.5
seconds.
R
– Angle
Right
With wings in a straight line, press the
R
button to move both wings to
the angle right position to cast snow to the driver's right side. The right
wing retracts while the left wing extends. Function times out after 5.5
seconds.
NOTE: If control function times out
before desired blade movement is
complete, refer to the General
Diagnostic Table in the
Troubleshooting section of this
guide.
SYSTEM OVERVIEW – CONTROLS
