8.4.2 when the system is on and the heating function is on, press“ ”on the remote
controller, at this time the LCD displays temperature. Temperature unit blinks.
Then press“ ”or
“
”，
temperature will go up or down 1
℃
；
if press
“ ”
or
“ ”
more than 2S
，
temperature will increase or decrease by“1
℃
/0.5S”
；
If within 5S
“ ”or
“
”
is not pressed
，
then temperature last set will be the setting
temperature. And system will exit temperature setting. LCD displays current water
temperature in static state.
8.5 Temperature setting range
：
35
℃
--45
℃
8.6 If the temperature sensor occurs error, LCD displays “E1” and the controller
sounds “di…di…”,in this case the heater cannot be start.
9. Blue tooth music play
9.1 When the system is on and FM is off, pressing“ ”for 2Sor press“ ”for 2S
on the remote controller
，
to disconnect the equipment connected with the blue tooth
currently. And entering blue tooth pairing state. LCD displays“PAIR”.
9.2 when the system is on, pressing constantly“
、
”，
and moving the cursor to
“ ”，
pressing continuously“ ”
，
till the LCD displays“BT--C”
，
then blue
tooth music will be started
；
press again“ ”
，
till
“
BT--C”disappear
，
blue tooth
music play will be off.
9.3 blue tooth name
“
PROW-BT”. If pairing is not done
，
LCD displays“BT--C”;
if pairing is done
，
LCD displays“BT--C”.
9.4 When the blue tooth music is started, press
“ ”，
when LCD displays“P--N”
，
by pressing“ ”to choose nest song
，
by pressing
“ ”
to choose the last song
；
by press “ ”and “ ”next song and last song can also be chosen.
9.5 When the blue tooth music is started
，
pressing“ ”for 2S
，
to play or pause.
9.6 When the blue tooth music is started
，
pressing“ ”
，
when the LCD displays
“VOL”
，
it enters volume adjusting state. By pressing“ ”to increase volume
，
and
“ ”todecrease volume. Volume adjusting range is from 0-20,total 21.
IV
、
Remote control operation instruction
1. When any function button works, there is a sound of “di…”
2. For function button operation on the remote controller , except the ones with
special instruction,
they are all the same with the buttons on the control panel.
V
、
Precautions
for
Installation
and
Use
Users must carefully read the following precautions to ensure the normal use of the
product,extension of its service life and the personal safety
：
1. Users must install loads in strict compliance with the circuit diagrams and
parameters supplied by our company.
2. The ground wire must be connected to the power supply line with good grounding.
3. The end user should use power supply cables in 3 x 3mm2 or wider cable diameter. .
According to the National standards (GB). The socket should be of 30A or above
according to the National standards
(
GB).
4. The end user should install air-break or leakage switch of 30A or above according
to the National standards (GB).
5. Strictly check the power supply wiring of the control box. Power on to use only
after no errorsconfirmed.
Manual
8
