User Guide
4. Part Replacement
4.7 DIMM Replacement
Figure 105:
Safety Latch Release
e.
As the chassis is slid into the rack, position one installer at the rear of the rack to ensure
that the pegs on the sides of the cover will slide correctly into the rear cover alignment
brackets on both sides of the rack. If the chassis does not install smoothly or snags, check
that the rear cover alignment brackets are not interfering with the chassis sidewalls, and
try again.
Step 23 :
Now that the chassis is installed, test the installation by sliding the enclosure in and out of the
rack a minimum of three times. If the enclosure binds, catches, or displays any incorrect motion
or behavior repeat the installation.
Note:
Adjustments of the vertical rack rails may be required to fix any issues that
may occur.
Step 24 :
Install the CMA(s).
Note:
CMA has one arm, to be installed at the lower position. This arm should
have the elbow on the left side.
a.
Orient the CMA so that the elbow is on the left hand side.
b.
Attach all three of the connectors to the brackets on the rails. There should be one at the
elbow side and two at the other end.
108
