User Guide
3. Management
3.2 Part Replacement
Figure 289:
Fan Module Secure
d.
Verify that the Fan Module is securely latched into the chassis by pulling on the release
handle and ensuring the Fan Module does not move when pulled. Reinstall the Fan Module
if it is not securely installed into the chassis.
e.
Install each Fan Module in the same way the first was installed.
Step 15 :
Power up the E3000:
Figure 290:
Enclosure Power and Data Connections
a.
Connect the power cables into each of the PSUs at the rear of the unit. The BMC Module,
PSUs, and Fan Modules should all power on.
b.
Verify the LEDs are illuminated on the PSUs.
c.
Tighten the cable retention clips by sliding each one forward on the PSU until it stops near
the cable connector. Doing this will ensure that the retention clip functions properly in the
event the cable is pulled on.
164