Westell PS51080, Руководство пользователя

Страница: 40 / 50

WESTELL.COM
© 2016 Westell Technologies 20 April 2016 Doc. No. 030-300736 rB
1.877.844.4274 Page 40 of 50
Figure 6-5: Control Mode Page, continued
Item # Section
8 Isolation
Isolation Value When power is on, an isolation check is
performed and the values display.
Isolation Measured isolation value (air interface
attenuation value) between donor antenna
and service antenna. The isolation check can
be performed with the RF on or off.
On = Measure the Isolation and display the
value in the Isolation Value field
Off = Do not measure the isolation
Isolation Recheck The isolation check can be performed with the
RF on or off.
Isolation Attenuation This allows control of the isolation
attenuation. After isolation check, attenuation
is set automatically (0 to 30).
Note: Neither the isolation check nor recheck will indicate a change in
power levels if the unit’s own power has been switched off.
9 VSWR
DL/UL
Ratio VSWR Ratio Status Display, 0 to 30.
Limit VSWR Ratio Alarm Limit, Set 0 to 30.
On/Off VSWR Alarm Display Enable (On)/Display (Off).
10 Location
Company Company information display
Address Address information display
City City information display
State State information display
Contact Contact information display