West Mountain Radio RIGblaster duo, Руководство пользователя

Страница: 20 / 30

20
STATION HOOKUP DIAGRAM
.
The diagram on the preceding page shows a
RIGblaster duo
integrated into an Amateur Radio
Station consisting of two transceivers, a desktop computer with sound, two speakers, a foot switch and
LED transmit ready LED indicators. This is a diagram of the connections for a fully integrated station.
The only accessory that is not shown is a pair of stereo headphones which would be plugged into the
front of the
RIGblaster duo
.
The primary features are indicated with blue lines and are explained first. The optional advanced
features are indicated in red and will be explained later in this manual. For each numbered wire there is a
description of its function and the end points to which it connects.
- The station microphone with an 8 pin round metal connector is connected to the Microphone
Connector (F1) on the front of the
RIGblaster duo
. Note: in order for this cable to function
properly with a particular microphone, jumpers must be installed correctly inside the RIGblaster
on the “P10” jumper block, see page 24.
“RIG MIC/PTT’
-
This is a supplied microphone cables connecting “MIC OUT A”
(R19)
to radio A’s front
panel microphone input. It is either a 8 pin round metal connector to a square RJ45 Modular
connector or an RJ45 to RJ45 Modular. Other cables for 4 pin round, RJ22 6 wire Modular or
special 6’ long cables are available. Note: in order for this cable to function properly with a
particular radio jumpers must be installed correctly inside the RIGblaster on the “P2” block. See
page 25.
- This is a supplied microphone cables connecting “MIC OUT B” (R19) to radio B’s front
panel microphone input. It is either a 8 pin round metal connector to a square RJ45 Modular
connector or an RJ45 to RJ45 Modular. Other cables for 4 pin round, RJ22 6 wire Modular or
special 6’ long cables are available. Note: in order for this cable to function properly with a
particular radio, jumpers must be installed correctly inside the RIGblaster on the “P3” block. See
page 25.
“RECEIVE AUDIO IN/OUT”
- This is a supplied stereo mini plug Patch Cord that connects the Computer Sound Card -
Line In (usually blue) to the
RIGblaster duo
“RCV OUT” (R14) . This connection allows
Amateur Radio sound card software to monitor the signals from both radios. Note: For a laptop
computer you would use the microphone input .
- This is a supplied stereo mini plug Patch Cord that routes speaker level audio from Radio
A’s speaker output to the
RIGblaster duo
’s “RADIO A IN” (R13) . It provides a path for
audio from the radio to the
RIGblaster
. This normally disables the built in speaker in the radio
allowing you to use the main station speakers and headphones driven by the RIGblaster . Note:
for radios with stereo (left and right) dual receive you must change the default setting of the P6
jumpers (see advanced options page 27).