8
Grease
Tube
Arrow
7
97
25
9
2
23
22
53
79
95
7. Apply a generous amount of the included
grease to the Pivot Axle (97) and to two Wave
Washers (95).
Insert the Pivot Axle (97) into the Upright (2)
and center it.
Slide a Waver Washer (95) onto the left side of
the Pivot Axle (97).
Slide a Handlebar Spacer (25) onto the short
tube on the Left Handlebar (9). Rotate the
Handlebar Spacer so that the small arrow
points toward the floor.
Slide the Left Handlebar (9) onto the left end of
the Pivot Axle (97). Finger tighten an M8 x
25mm Patch Screw (22) and an M8 Large
Washer (53) into the end of the Pivot Axle.
Attach a Handlebar Cap (23) by pressing its
small tabs into the Handlebar Spacer (25).
Assemble the Right Handlebar (not shown)
in the same way.
Tighten both M8 x 25mm Patch Screws (22)
at the same time.
6
6. Identify the Left Handlebar (9), which is marked
with an “L” sticker.
Insert the Left Handlebar (9) into one of the
Handlebar Legs (79).
Make sure that the
hexagonal holes are in the indicated loca-
tion.
Attach the Left Handlebar (9) to the Handlebar
Leg (79) with two M8 x 45mm Button Bolts (50)
and two M8 Locknuts (46).
Make sure that the
Locknuts are inside the hexagonal holes. Do
not tighten the Button Bolts yet.
Repeat this step for the Right Handlebar (not
shown) and the other Handlebar Leg (not
shown).
50
46
Hexagonal
Holes
9
79
