WESCO NAVY WMA504EP, Руководство пользователя

Страница: 62 / 186

❑
Programming the Wash Speed
Standard reversing wash speed is between
≅
40 and 50 RPM. (
≅
Verify exact value at table 3.6.B.)
For some special applications the drum should only turn very slowly.
- Speed Limits
The minimum programmable wash speed is 10 RPM.
The maximum programmable wash speed is 40 - 60 RPM, depending on machine size.
❑
Programming Extraction speed
Extraction
≅
[150 - 1165] RPM
An Intermediate spin between two sequences should be about ½ of the max spin.
Between 90 and 150 RPM (
≅
Verify exact value at table 3.6.B.) it’s not allowed to program a steady
speed, as the machine could VIBRATE TOO MUCH.
- Speed Limits
Check table 3.6.B with the minimum and maximum speed limits. The limits differ depending on the
maximum allowed g-force at high spin for each washing machine type.
❑ Programming Supplies
Up to 4 Supplies can be programmed at the same time in a sequence.
If Liquid soap pumps have been installed on the washing machine, then these pumps will be activated
by programming a time value for the corresponding supply signal 1, 2, 3, 4, 5, 6, 7, 8.
- Time Limits
The maximum programmable time is 99 Seconds
If the time is 0 Seconds then the supply will NOT be activated at the wash process.
!
ATTENTION!
IF FOR SOME SPECIAL APPLICATION MORE THAN 4 SUPPLIES MUST BE PROGRAMMED IN THE
SAME SEQUENCE, THIS CAN BE SOLVED BY PROGRAMMING THE SAME SEQUENCE TWICE; ONE
AFTER THE OTHER. SPLIT THE WATER LEVEL ( SO IT WILL TAKE WATER FOR THE SECOND FILL,
say 60%, 100%), STEP TIME, AND THE NUMBER OF SUPPLIES, OVER THE TWO SUBSEQUENT
SEQUENCES. PROGRAM A „NO DRAIN“ BETWEEN THE TWO SEQUENCES TO AVOID DRAINING
THE WATER. SET TEMPERATURE THE SAME FOR BOTH PARTS.
22