WESCO NAVY WMA504EP, Руководство пользователя

Страница: 134 / 186

DIAGNOSE:
DIAGNOSE:
FAILURE 32: VERIFICATION FAULT INVERTER
Fault 32 occurs if a wrong parameter is detected at the verification of the inverter parameters. After writing
the inverter parameters in the inverter, the parameters are verified one by one to ensure that they have been
correctly loaded. This fault message means that at least one of the dedicated inverter parameters is wrong.
As a result the inverter will not work in a correct way.
FAILURE 35: WRONG SOFTWARE VERSION
When a totally new software that isn’t backward compatible with previous software versions is loaded, then
the software will detect that the old and new software's are not compatible.
You have to reconfigure the Wash Computer. See chapter 4.
!
ATTENTION!
ALL THE CUSTOM SETTINGS WILL BE ERASED IN THE WASH COMPUTER BY LOADING THE
FACTORY SETTINGS.
After reconfiguration of the Wash Computer, fault 35 can only be erased by switching the power Off/On.
FAILURE 36: THE LINEN IS NOT CORRECTLY DISTRIBUTED IN THE STAGE
BEFORE THE START UP OF THE SPINNING SEQUENCE
This error occurs when the linen is incorrectly distributed in the washer during the distribution stage (before the
transition from distribution revolutions into high revolutions).
In case that the unbalance detection system is activated, the machine attempts to redistribute the linen better. If
there still is unbalance in the machine, it lowers the revolutions of the spinning sequence based on the
unbalance magnitude. This function prevents machine overload by uneven distribution of the filled-in linen and
thus increases the service life of the machine.
DIAGNOSE:
1. Unbalance may be caused by inserting only half
the linen load into the machine.
Always fill in the machine with a full load of linen.
Do not insert any other materials than textile
materials (fabrics).
FAILURE 37: DRAIN FAILURE AT THE SPRAY SEQUENCE
Failure 37 occurs when the electronic timer detects that the water is not drained after 3 minutes at the Spray
Sequence.
94
1. Check if the correct machine type
is selected in the Configuration Menu.
If the wrong machine type is selected, enter the right
machine type.
2. Check if the door is closed and locked. If the door is not closed, close the door.
If the door is not locked, repair the door lock system.
3. Check if the inverter is energized. If the inverter is not energized, check the power to the
inverter (see fault 27).
4. Write the parameters once more
into the inverter.
If the fault is persistent, contact the manufacturer.
1. Check the drain tube of the washing machine. If the drain tube is blocked: repair the drain tube.
2. Check the drain valve. If the drain valve is defective: replace the drain valve.
3. Check the wiring:
When the drain valve is switched Off, the drain
valve should be open. (normal open)
If the wiring is damaged: repair the wiring.