WESCO NAVY WMA504EP, Руководство пользователя, Страница: 101 / 186

6.9. WASH TIME
Once the program has been started, the remaining cycle time is displayed.
The clock symbol indicates whether the time of the running cycle is being counted down or
not. If the clock symbol is not flashing, it means that the cycle time is not being counted down.
The time for which the symbol is not flashing is the extra time.
The total wash time = programmed time (1) + the extra time (2+3+4+5)
1. The programmed time of the processes.
2. The extra time for taking water.
3. The extra time for draining (if the water is not drained in 30 sec and the extended
drain time is started)
4. The extra time for heating if „Wait for temperature“ is selected.
5. The extra free run time at the end of the spin sequence.
The display of remaining cycle time can be disabled in Payment menu – item “Show Prog Time.”
6.10. PROGRAM END
The time on the display counts down until 0.
At the end of the cycle, the door lock is released, the display shows the UNLOAD message
and it is possible to open the door (unload the laundry).
Open the door and unload the machine.
The Message UNLOAD will be erased and the machine is ready to start a new program.
The program overview is shown.
6.11. WATER FILL PROCESS
Depending on the water temperature the cold and hot inlet valves will be opened.
The water level is measured by an electronic water level sensor.
If the Temperature Balance function is enabled, the Wash Computer will control the water
temperature until the target temperature is reached. For Hot wash programs, extra heating
will be required after the fill process to reach the programmed hot water temperature.
In the standard wash tables you will find a Normal Low and Normal High water level.
These are the standard water levels :
- The Normal Low water level is used for the Prewash, Wash and Soak sequence.
- The Normal High water level is used for the Rinse and Final Rinse sequence.
The water level can only be programmed between two limits:
- The lower limit is above the heating elements and the temperature sensor.
- The upper limit is in the middle of the wash drum.
6.12. HEATING PROCESS
When „No Wait for Temperature“ (No Wait for Heat) is selected:
- The machine will heat until the time of the specific wash step is over or if the
programmed temperature was reached.
- Even if the programmed temperature is not reached, the program will start the next
sequence if the time of the sequence is over.
61