49
2D-/3D Profile Sensors
Pin function
• Profile enable: Input function which enables profile recording for as long as the signal
is applied.
NOTE!
In combination with the “fixed” mode, the “profile active” pin function is used to
start the specified number of profiles. If the signal remains continuously active,
the sensor transmits a multiple of the defined number of profiles (see also “Num-
ber of Profiles” under “Trigger Settings” in the “Profile Display” menu).
Pin function
• Encod. reset: Input function for resetting the internal encoder counter to “0”.
Internal load
Connects an internal resistor to the input (pull-down).
Internal load of 2 mA (on/off).
Input function
Determines whether the input responds to supply voltage or 0 V.
This makes it possible to invert any pin function.
Output
Sets the output’s polarity (push-pull, PNP, NPN).
Output function
The output can be configured as normally open (NO) or normally closed (NC).
NOTE!
The above listed functions can be set individually for each of the 4 configurable I/Os
(with the exception of “Encod. E1+E2” which is limited to I/O1 in combination with I/O2).
