38
Integrated Web Server
Network load
Indicates the network’s current transmission load (at the sensor side). Continuous
utilization of close to 100 % should be avoided because overrun might otherwise occur
at the sensor’s network buffer. Utilization can be influenced by reducing the measuring
rate or by changing the content of the transmission protocol.
Network buffer
Indicates internal network buffer occupancy as a percentage. Momentary increases in
occupancy are no problem. However, if occupancy increases continuously, network
utilization must be reduced (see description of “network utilization”), in order to prevent
the loss of profile data.
NOTE!
Bandwidth may be too narrow. Check the network settings at the PC and/or the
LED display. If the orange LED lights up, transmission speed is only 10 Mbit
(see section “3.5 LED Display”, page 26).
Temperature
Displays current temperature inside the sensor housing. Depending on how the sensor
is mounted, this temperature is 15 to 25° C above ambient temperature.
In order to avoid damage and a reduced service life, use the sensor within the specified
temperature range only.
NOTE!
As of an internal temperature of 60° C, the sensor is in its critical temperature
range.
Encoder
Left: HTL encoder counter (rotary encoder)
Right: RS422 TTL encoder counter (rotary encoder)
Connected with
Displays the IP address of the PC or the control unit with which the sensor is connected.
Sensor Parameter Set
This field provides the user with the opportunity of saving all of the selected settings to the sensor and
retrieving them later. The values saved under “Standard” are loaded automatically when the sensor is
started up.
OLED Display
This field shows the current content of the OLED display. It’s refreshed approximately once per second.
Dynamic Page Content
Depending on which category
is selected, the corresponding page content is displayed.
Category Selection
The integrated website offers four different categories:
•
Device, General
Overview page with general information regarding the sensor.
•
Device Settings
Network
and display settings can be changed, and reset commands as well as a sensor restart can be
triggered.
•
2D/3D Profile Settings
Profile display with option for parameter settings.
•
I/O Settings
Function and performance of the four configurable I/Os can be selected.
