Wenglor A1P05, Руководство по эксплуатации

Страница: 12 / 21

12
Sensors for your success www.wenglor.com Sensors for your success www.wenglor.com
EN
Adjusting Off-Delay
• Set the rotary selector switch
Ý
to Off-Delay
è
Current Off-Delay is displayed (see “Table 1” on page 7)
• Briefly press the plus key

è
Off-delay is increased
• Briefly press the minus key 
è
Off-delay is decreased
• Set the rotary selector switch
Ý
to RUN
Indication of Delay Time Settings
Delay LED at minus key

LED at plus key

0 ms* 1× blink, pause, 1× blink Off
1 ms 2× blinks, pause, 2× blinks Off
2 ms 3× blinks, pause, 3× blinks Off
5 ms 4× blinks, pause, 4× blinks Off
10 ms Off 1× blink, pause, 1× blink
20 ms Off 2× blinks, pause, 2× blinks
50 ms Off 3× blinks, pause, 3× blinks
100 ms Off 4× blinks, pause, 4× blinks
*Default setting Table 3
8.6. Trigger Function at Pin 5
• Set the rotary selector switch
Ý
to trigger
• Apply the trigger signal (PNP) to input W (pin 5)
è
Triggering is executed by a positive signal edge
è
The Sensor performs a one-time measurement
è
The outputs are updated once only
• Disconnect the signal from the trigger input
8.7. Returning All Sensor Settings to their Default Values
Sensor settings can be returned to their original factory default values (see “Table 4” on page 7)
• Set the rotary selector switch
Ý
to RS-232
• Simultaneously press the plus  and minus  keys
è
The LEDs at both keys start blinking
è
The LEDs stop blinking after approximately 5 seconds
• Release both keys
• The Sensor has been returned to its factory default settings