5
To begin the assembly of the Attic:
1.
Hold a front frame (item 2) weldment with
the 3/4" x 1 1/2" tubing horizontal. Some
assistance may be required.
2.
Position a side frame (item 3) behind the
front frame (item 2).
(figure A)
Note:
The offset holes allow the side frame to
be flush with the bottom of the front
frame and allow a height difference
between the tops of the two frames.
This gap is where the floor fits when
the unit is turned over.
3.
Insert the 2" long machine screw (item 7)
through the front frame and then through
the side frame. Screw heads on the
outside of the front frame. Assemble the
nuts (item 6) snugly with the knurl locking
feature toward the tube.
(figure A)
4.
Position the other front frame (item 2) to
the back of the side frame and repeat step
3.
(figure B)
5
Position the other side frame (item 3)
between the two front frames. Install the
hardware as described in step 3.
(figure C)
6.
Once the front and back frames are
uniform with the side frames flush with the
ends of the front frames and all frames
resting on the corrugation or floor, hold the
corners square and tighten all fasteners.
A
SSEMBLY
3
7
6
2
figure A
figure B
figure C
2
3
