18
Operating instructions (continued)
When the Blade is tilted to the right as far as it will go, the Blade should be at a 90ºangle to the
Saw Table and the Bevel Indicator on the Ruler should point to 0º.
Please note:
When the Blade is at 90º to the Table Saw, the Blade should be square with the
Saw Table.
WARNING!
The Bevel Lock Knob must be tightened during all cutting operations.
45º and 90º positive stop adjustment
The Table Saw is equipped with positive stops for rapid and accurate positioning of the Blade
at 45º and 90º to the table.
Before making ANY adjustments, make sure the Table Saw is unplugged and the Safety Key is
removed.
To adjust the positive stop at 90º, loosen the Bevel Lock Knob and move as far to the left as
possible. Then tighten the Knob.
Place a level or square (not included) on the Table (109) with one end blade to make sure Blade
is at 90º. If not, loosen the Bolt (110) a few turns and tilt Blade until at the correct angle.
Tighten the Bevel Lock Knob and then tighten the Bolt (110).
To adjust the positive stop at 45º, loosen the Bevel Lock Knob and move as far to the right as
possible. Then tighten the Knob.
Place a level or square on the Table with one end blade to make sure Blade is at 45º. If not,
loosen the Bolt (111) a few turns and tilt Blade until at the correct angle.
Tighten the Bevel Lock Knob and then tighten the Bolt (111).
Aligning and adjusting the rip fence (146)
WARNING!
A misaligned Fence can cause kickbacks and jams. To reduce risk of injury,
always maintain proper Fence alignment. The Rip Fence must be parallel with the Blade and
Table grooves.
Lift up the Fence Handle (26) and move the Fence along the gauge slot until sliding it to the
desired location.
Verify that Fence is parallel, and then push down on the Handle to lock the Fence in place.
A Draw Pole locks the Fence in place. To adjust the Draw Pole, loosen the Bolt that connects
the Draw Pole to the Fence.
