16
Assembly (continued)
6.
Move the Leg Assembly to the desired floor surface working location. Then, firmly tighten
all hardware, using an appropriate size wrench (not provided).
To mount the leg stand on table saw base:
1.
With assistance, place the Table Saw upside down on a flat, level, smooth surface (i.e.,
cardboard) on the floor. Then, place the Leg Assembly upside down on the Base of the
Table Saw.
2.
Align the two mounting holes on the each of the two End Braces with the two mounting
holes on each end of the Base. Secure the End Braces to the Base, using four Hex Head
Bolts and four Hex Nuts.
3.
With assistance, stand the 10" Table saw upright.
To install the handwheel
1.
Remove the Bolt (27) from the Screw Rod (54).
2.
Place the Handwheel onto the Screw Rod. Fasten into place by using the Bolt.
To assemble the blade guard
1.
Unplug the Saw and remove the Safety Key (18) from the switch (17).
2.
Position the Blade (96) 90º to the table and lock in place.
3.
Position the recessed end of the Splitter Bracket (119) against the end of the Pivot Plate
(117) and fasten in place using the Spring Washer (3), Mat Washer (4) and Bolt (116).
Please note:
Do not fully tighten the Bolt at this time.
4.
Remove the Wing Nut (121), Flat Washer (50) and Spring Washer (3) from Splitter Bracket.
5.
Position the Splitter (131) against the Splitter Bracket. Make sure the tabs on the Splitter
Bracket are INSIDE the slot of the Splitter.
6.
Replace the Wing Nut (121), Flat Washer (50) and Spring Washer (3).
7.
Make sure there is at least a 1/8” gap between the bottom edge of the Splitter and the top
surface of the Table (109) and that the tabs are on the INSIDE slot of the Splitter.
8.
Use a framing square (not included) to make sure the Saw Blade and Splitter assembly are
square. If not square, loosen the Splitter Bracket and adjust until the Splitter is properly
aligned with the Saw Blade. Then tighten all screws and bolts.