23
Operating instructions (continued)
Place a support (not included) that is the same height as the Table Saw behind the Saw.
Turn the Switch to “ON”.
Let the Blade build up to full speed before moving the workpiece into the Blade from the front
of the Saw.
WARNING!
To prevent injury, place hand closest to Blade on the Miter Gauge Lock Knob
and keep Hand furthest from Blade on the workpiece.
Once cut is made, turn off Table Saw. Wait for Blade to come to complete stop before
removing any part of workpiece.
Making a rip-cut
Turn the Handwheel counterclockwise until Blade is set to correct depth of workpiece.
Set the Blade to 0º and position Fence at desired distance from Blade for cut. Lock Fence in
place.
Place a support (not included) that is the same height as the Table Saw behind the Saw.
Make sure wood is clear of Blade before turning on Table Saw.
Use Push Stick or push block to move the wood through the cut and past the Blade.
WARNING!
Do not push a small piece of wood into the Blade with your hand. Always use
Push Stick or push block. See Figure 3, below.
To reduce possible injury should kickback occur, stand to side of the workpiece as it contacts
the Blade.
WARNING!
Do not stand in the line of cut.
Once cut is made, turn off Table Saw. Wait for Blade to come to complete stop before
removing any part of workpiece.