4
Original Operating Manual
Warning
DANGER!
Danger when opening up the tool, as live components and
connections are exposed. Therefore, before opening it, unplug the tool
to ensure disconnection from the mains. Before putting into operation,
check power supply cord and connector as well as extension cable for
electrical and mechanical damage.
Incorrect use of the Hot Air Tool (eg. overheating of the material) can
present a
fire and explosion hazard
, especially near combus t ible
materials and explosive gases.
Do not touch the heating element housing and air nozzle when
they are hot as they can cause
burns
. Let the tool cool down. Do
not point the hot air flow in the direction of people or animals.
Attention
The
voltage rating
stated on the tool must correspond to the mains
voltage.
For personal protection on building sites we
strongly recommend
the tool be connected to a
RCCB
(
R
esidual
C
urrent
C
ircuit
B
reaker).
The tool must be operated
under supervision.
Heat can ignite flam-
mable materials which are not in view. The machine may only be used
by
qualified specialists
or under their supervision. Children are not
authorized to use this machine.
Protect tool from
damp
and
wet.
Repairs
should only be carried out by
authorized service points
.
Restricted to use with
original Weldy accessories and spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Leister Technologies AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland,
confirms that these products, in the version as brought into circulation through
us, fulfils the requirements of the following EC directives.
Directives:
2006/42, 2014/30, 2014/35, 2011/65
Harmonized EN 12100, EN 55014-1, EN 55014-2, EN 61000-3-2
Standards:
EN 61000-3-3, EN 62233, EN 60335-2-45, EN 50581
Kaegiswil, 31.07.2017
Bruno von Wyl, CTO
Christoph Baumgartner, GM
Applications
This hot-air tool is intended for all of the hot-air applications listed here, subject to compliance with safety regulations and the utilization of original Weldy accessories:
• Welding of all thermoplastic synthetic materials • Shrinkage & forming of thermoplastic synthetic materials
• Drying of watery-moist surfaces
• Welding of foils & plastic sheeting
• Activation/detaching of solvent-free adhesives & hot melt adhesives • Soldering of copper pipes, solder connectors & metal foils
DE
EN
FR
ES
PT
IT
NL
DA
SV
NO
FI
EL
TR
PL
HU
CS
SK
RO
SL
BG
ET
LT
LV
RU
JA
ZH
AR
TH
