Welch Allyn Hillrom H12+, Руководство пользователя

Страница: 25 / 51

INTRODUCTION
21
Recorder Setup
Opening and Closing the Battery Door
The SD card slot and the battery compartment are accessible via the battery door of the H12+ recorder.
To open the battery door, hold the latch (
1 ) down and then depress and slide the battery door ( 2 ) until it
stops. Lift and remove the battery door.
To close the battery door, replace the battery door halfway, matching the grooves on the H12+ recorder
as shown in the diagram, and slide in the opposite direction of the arrow (
2 ) until the door latches into
place.
Inserting the Battery
The H12+ recorder is powered with a single AA alkaline battery.
Open the battery door of the H12+ recorder. If needed, remove and discard the old battery. Insert a new
battery with the ‘+’ end aligned with the top of the recorder, as indicated on the back label. Close the
battery door of the recorder.
NOTE: The H12+ recorder requires a full capacity battery to record a 24-hour or 48-hour
session. The H12+ recorder will test battery voltage upon start up and will not allow the
recording to begin if there is insufficient voltage. Always use a new battery to ensure operation.