Weinmann BiLevel-ST VENTImotion WM 24800, Инструкции по обслуживанию и ремонту

Страница: 47 / 64

Repairguide for VENTImotion/VENTIlogic 47
7.14 Replace top part of housing
Tools and equipment required
• ESD protected work-station
• 3 mm Allen key
• Phillips screwdriver, size 1
1. Open the device (see section 7.2 on
page 31).
2. Remove the mains supply unit (see section 7.4
on page 33).
3. Remove the power board (see section 7.5 on
page 34).
4. Remove box and filter holder (see section 7.6
on page 35).
5. Remove the control board (see section 7.8 on
page 39).
6. Remove the device outlet (see section 7.10 on
page 42).
7. Remove the lock washers from pins
79
.
8. Push pins
79
out of the hinges and take handle
78
off the top part of the housing.
9. Remove mains input connector
80
and cable
securing clip
81
.
You have now dismantled all parts. Now start as-
sembling into the new top part of the housing
36
.
10. Take the new top part of the housing
36
in your
hand and insert handle
78
in the top part of the
housing.
11. Push pins
79
into the hinges and fit the lock
washers.
12. Fit the device outlet (see section 7.10 on
page 42).
13. Refit the display and the control board (see
section 7.8 on page 39).
14. Refit the box and filter holder (see section 7.6
on page 35).
15. Refit the power board (see section 7.5 on
page 34).
16. Refit mains input connector
80
and cable secur-
ing clip
81
.
17. Refit the mains supply unit (see section 7.4 on
page 33).
18. Close the device (see section 7.3 on
page 32).
19. Test the device (see "4. Test the device" on
page 13).
Obe
80
81
79
Lock washers
78