Weidmüller PTX800A, Руководство по эксплуатации

Страница: 43 / 48

4
•Modifications
Analogueoutputtype
The analogue output type (current/voltage) is set by internal push fit
jumper. To change the output type:
Changetheoutputtypepushfitjumper:
1. Gently remove the backplate (it is held in place by four lugs).
. Slide the electronics from the housing.
. Change the jumper location to the required setting (see diagram
above).
4. Look inside the housing and note that there are connectors that
mate with the display board.
5. Slide the electronics gently back into the case. Carefully moving the
board until the keypad connectors engage with the display board.
6. Replace the backplate.
Changetheoutputtypeinthesoftware:
1. Power up the instrument and start the setup routine.
. While the software version number is flashing, remove the security
link and press PGM .
. The display will show a number as shown in the table below.
Number
0 1 2 3 4 5
InputType mA V mA V mA V
Outputtype mA mA V V None None
4. Change the number to suit your input and output types.
5. Replace the security link and press
PGM .
Changetheoutputrangesettings:
6. Scroll through the setup and change the output type and range
settings - you will be required to calibrate the outputs.