1.
Before beginning, be sure that you have read
and understood the information on page 5.
Locate and open the parts bag labeled
“FRAME ASSEMBLY.”
Press a 50mm Square Inner Cap (67) into each
end of the Butterfly Base (1).
Insert four M8 x 61mm Carriage Bolts (75) and an
M10 x 89mm Carriage Bolt (95) up through the
indicated holes in the Butterfly Base (1). Place the
Butterfly Base flat on the floor. Note: If the Bolts
fall out, secure them by putting a small piece of
tape over the head of each Bolt.
2.
Press three 50mm Square Inner Caps (67) into
the Center Base (2). Insert an M10 x 89mm
Carriage Bolt (95) up through the indicated hole
in the Center Base.
Note: There are three kinds of support plates.
The main difference between them is the dis-
tance between the holes. When you need a
support plate, find the kind with holes that will
fit over the bolts you are using.
Attach the Center Base (2) to the Butterfly Base (1)
with two M8 x 66mm Bolts (89), a Medium Support
Plate (109), and two M8 Nylon Locknuts (86). Do
not tighten the Locknuts yet.
1
3.
Press a 50mm Square Inner Cap (67) into the
end of the Press Base (3).
Insert four M8 x 61mm Carriage Bolts (75), an
M10 x 63mm Carriage Bolt (76), and an M10 x
92mm Carriage Bolt (112) up through the indicat-
ed holes in the Press Base (3).
Orient the Press Base (3) with the indents around
the indicated holes on the bottom. Attach the Press
Base to the Center Base (2) with two M8 x 66mm
Bolts (89), a Medium Support Plate (109), and two
M8 Nylon Locknuts (86). Do not tighten the
Locknuts yet.
3
6
Frame Assembly
75
1
67
75
67
95
75
75
76
3
Indent
2
86
67
109
89
2
95
86
112
2
67
1
89
86
Hole
109
86
