19
45. Remove the M10 Nylon Locknut (90) used in
step 43.
Wrap the Low Cable (71) under a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the M10 x 121mm Bolt (102) used in step 43 with
the M10 Nylon Locknut (90). Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
46. Attach the Low Cable (71) to the Leg Lever (13)
with an M8 x 68mm Shoulder Bolt (108), an M8
Washer (100), and an M8 Nylon Locknut (86).
Make sure that the flat side of the eyelet on
the cable (see the inset drawing) is against the
leg lever.
45
90
71
102
4
35
38
46
100
108
86
13
71
47. Identify the Press Cable (72). It is approximately
387 5/8” long and it has a ball on one end and a
threaded shaft on the other.
Wrap the Press Cable (72) over a 90mm Pulley
(35). Attach the Pulley to the Press Top Frame (9)
with an M10 x 89mm Bolt (111), an M10 Washer
(97), and an M10 Nylon Locknut (90). Make sure
the Cable is between the Pulley and the pin on
the Press Top Frame.
47
35
111
72
90
Pin
97
9
48. Route the Press Cable (72) over the 90mm Pulley
(35) that was attached to the Press Top Frame (9)
in step 16. Make sure the Cable Trap (38) is
positioned to hold the Cable in the groove of
the Pulley. Properly tighten the M10 Nylon
Locknut (not shown) attached to the M10 x 97mm
Bolt (77).
48
35
72
77
9
38
Flat
Side