32. Identify the Ab Cable (74). It is approximately
226 1/2” long, and it has a ball on one end and
an eyelet on the other.
Wrap the Ab Cable (74) over a 90mm Pulley (35)
as shown. Place two Pulley Covers (39) over the
Pulley, so that the large tabs are on the indicated
side. Attach the Pulley and Pulley Covers to the
Butterfly Upright (4) with an M10 x 97mm Bolt
(77), two M10 Washers (97), and an M10 Nylon
Locknut (90). Make sure the Cable is between
the Pulley and the pin on the Upright.
32
90
97
Pin
74
97
77
39
39
Large tabs
on this side
4
35
29. Wrap the Rear Cable (70) under a 90mm Pulley
(35). Attach the Pulley and a Cable Trap (38) to
the top hole in the pair of Pulley Plates (32) with
an M10 x 48mm Bolt (93) and an M10 Nylon
Locknut (90). Make sure the Cable Trap is posi-
tioned to hold the Cable in the groove of the
Pulley.
29
15
30. Wrap the Rear Cable (70) over a 115mm Pulley
(36) in the direction shown. Attach the Pulley
inside the indicated bracket on the Center Top
Frame (8) with an M10 x 45mm Bolt (94) and an
M10 Nylon Locknut (90).
70
93
38
90
31. Attach the end of the Rear Cable (70) to a “U”-
bracket (33) with an M8 Washer (100) and an M8
Nylon Locknut (86). Do not completely tighten
the Locknut; it should be tightened so that
only two threads of the Cable show past the
Locknut, as shown in the inset drawing.
Attach the “U”-bracket (33) to the Short Weight
Tube (44) with an M8 x 45mm Bolt (96) and an
M8 Nylon Locknut (86).
32
32
35
31
30
70
86
33
70
86
96
33
44
100
86
36
90
Bracket
8
94
70
