°°
CORFLEX.COM | 800 426 7353
1.
Place leg inside liner and position heel as
far back as possible. Close forefoot cover
over top of foot and fasten it snugly.
Fitting and Application
Marathon
TM
Air Walker
Ankle
Application Instructions
2.
Wrap liner around the front of lower leg
and secure with hook and loop closures.
POSITION FOREFOOT
COVER OVER TOP OF FOOT
WRAP LINER AROUND
FRONT/LOWER LEG
FOREFOOT COVER
The Marathon Air Walker features an
inflatable interior bladder that allows for a
custom fit while providing compression and
stabilization throughout recovery.
3.
Situate front shell over liner taking care
to properly position it over the inflation bulb.
Check that the inflate/deflate knob is in the
DEFLATE position before tightening straps,
this will allow air to escape from the bladder.
The front shell should not contact the foot or
leg, adjust as needed.
5.
Secure forefoot strap. Insert top strap
through outer shell slot, then through front
shell and fasten back on itself.
Fitting and Application
(continued)
4.
Insert initial ankle strap through plastic
buckle and secure strap. Always secure this
strap first to encourage proper positioning in
the walker.
6.
Test for desired comfort level, do not
overtighten straps.
INSERT STRAP THROUGH
REAR AND THEN FRONT
OUTER SHELL
SECURE ANKLE STRAP
FIRST FOR PROPER FIT
TIGHTEN STRAPS
UNTIL SECURE AND
COMFORTABLE
INFLATE LINER
CAUTION:
DO NOT
OVERINFLATE
LINER
CAUTION:
DO NOT
OVERTIGHTEN
STRAPS
PRESS AND RELEASE
INFLATION BULB AND
TURN THE INFLATE/
DEFLATE KNOB
COUNTERCLOCKWISE
7.
To inflate liner, turn the inflate/deflate
knob clockwise until fully opened and
press and release inflation bulb until liner is
providing support and comfort.
