Manual Vacuum-Lifter
Seite 5 von 7
Be sure to check before mounting the package if all required parts are present.
Refer to the dealer or manufacturer if the delivery is not complete.
The package includes:
•
1 x Vacuum Lifters T
•
1 x Operating and Instruction Manual
The vacuum lifter T is delivered to you and assembled.
An assembly of the individual parts is not required.
This chapter will teach you how to deal with the working fluid closer. Adhere strictly to use the
vacuum lifter T optimally to the operating instructions!
Make sure that the protective layer of the metal parts will not be damaged by sharp objects!
Any defects caused by faulty installation, are excluded from the warranty by the dealer or
manufacturer!
•
The stone slab to be lifted must be positioned so that you can be transported to the vacuum lifter
T. In such cases the suction of your vacuum lifter T can be fully seated.
•
The vacuum lifter T must be placed in the center of gravity of the stone slab. Now the rest area of
your vacuum lifter technical data refer.
•
Make sure that the stone slab to be lifted in the support area of the vacuum lifter T is dust-free and
dry. The surface of the stone slab to be lifted must be ground smooth and beyond the stone slab in
the contact area must be flat in the area where the vacuum lifter T!
• Now
the vacuum lifter T on the stone slab to be lifted in the middle of the center of gravity on the
Set.
•
Make sure that the sealing lip of the vacuum lifter T is fully seated on the stone slab. Make sure
that the sealing lip is not twisted when in place and positioned correctly.
•
In order to use the DL-injector, the air supply to the pneumatic nipple is connected first. The air
pressure must not exceed 6.0 bar.
•
Make sure that the vent valve is closed. The lever must here be turned to the right until it is at right
angles.
•
By positioning the vacuum by opening the ball valve in the arrow direction.
•
The pressure gauge is displayed, the current release of the vacuum.
•
When you reach a vacuum of -0.8 bar on the pressure gauge a sufficient vacuum is generated and
the aspirated stone slab can be transported. The evacuation takes about 1 minute when the security
vacuum tank not yet
The compressed air supply must not be switched off when the vacuum lifter T a stone plate is
sucked!
