Wegner Crane CFW500 series, Руководство по применению

Страница: 21 / 84

Crane
Crane | 21
The control connections (analog inputs/outputs and digital inputs/outputs) that must be made to connector of
the CFW500-IOD plug-in module of the CFW500 frequency inverter, for Crane Vertical or Horizontal Motion with
speed reference through the logical combination of digital inputs for 5 references, are presented next.
Figure 2.3 – Signals on connector of the CFW500-IOD plug-in module for crane with speed reference via the
logical combination of digital inputs
NOTE!
Refer to the CFW500 frequency inverter manual and the CFW500-IOD installation guide for further
details about connections.
Connector Default Function for Crane via Digital Inputs
1 DI1
B
or
ne S
up
er
ior
Digital input 1: Load Hoisting/Forward Command
3 DI2 Digital input 2: Load Lowering/Reverse Command
5 DI3 Digital input 3: Emergency Stop
7 DI4 Digital input 4: 1st DI for Speed Reference
9 +24V Power 24 Vdc (150mA)
11 DO1-RL-NO
Relay digital output 1 (DO1): Brake Release 13 DO1-RL-C
15 DO1-RL-NC
17 DI5 Digital input 5: 2nd DI for Speed Reference
19 DI6 Digital input 6: 3rd DI for Speed Reference
21 DI7 Digital input 7: Not Used
23 DI8 Digital input 8: Not Used
2 AO1
B
or
ne I
nf
er
ior
Analog output 1: Not Used
4 GND Reference 0 V
6 AI1 Analog input 1: Not Used
8 + 10V Ref10 Vdc for potentiometer
10 DO2 Transistor digital output 2 (DO2): No Fault
12 RS485 - A RS485 (Terminal A)
14 RS485 - B RS485 (Terminal B)
16 GND Reference 0 V
18 GND Reference 0 V
20 DO3 Transistor digital output 3 (DO3): Not Used
22 DO4 Transistor digital output 4 (DO4): Not Used
24 DO5 Transistor digital output 5 (DO5): Not Used