Wega WegaConcept 2Gr, Инструкция по эксплуатации

Страница: 17 / 32

17
Wegaconcept
User manual
ENGLISH
11.1 Automatic heating and foaming
Proceed as follows:
Immerge the tips of the autosteamer (
• 13 ) into
the beverage;
press the • or key, depend-
ing on the dose of milk in the jug;
wait until the dispensing is fin- •
ished;
when the dispensing has fi nished, •
the milk will be foamed and heated
to the preset temperature.
To stop dispensing ahead of time, press the same •
key;
to prolong the dispensing of steam, use the key •
“Manual steam” .
13
A
To increase or decrease the consistency of the
foam, slightly adjust the special regulator ( A ). Turn-
ing it clockwise will decrease the consistency, while
turning it counterclockwise will increase it.
Always proceed by performing slight adjust-
ments.
11.2 Automatic heating
Proceed as follows:
Immerge the tips of the autosteamer (
• 13 ) into
the beverage;
press the • key;
wait until the dispensing is fi nished; •
once the dispensing has fi nished, the milk will •
be heated to the programmed temperature, but
not foamed.
To stop dispensing in advance, press the same •
key;
to prolong the dispensing of steam, use the key •
“Manual steam” .
11.3 Manual heating and foaming
This control allows the user to use the auto-
steamer nozzle to heat and at the same time foam
the milk, letting him use it manually.
Proceed as follows:
Immerge the tips of the autosteamer (
• 13 ) into
the beverage;
press the • key;
To stop dispensing, press the same key again. •
11.4 Automatic cleaning
After 120 minutes of idle time the automatic
cleaning of the nozzle starts, lasting 15 seconds.
The message will appear on the display: "STEAM
CLEANING CYCLE"
A minimum amount of steam will exit the nozzle.
!
The autosteamer foaming is factory-adjusted,
in the testing phase of the machine. Therefore,
it is recommended to modify the adjustment
only if strictly necessary.