14
WWW.WEBER.COM
®
CROSSOVER
®
IGNITION SYSTEM OPERATIONS
If the Crossover
®
ignition system fails to ignite the Front burner, light the Front burner
with a match. If the Front burner lights with a match, then check the Crossover
®
ignition
system.
• Check that both the white
(1)
and black
(2)
ignition wires are attached properly.
• Check that the Crossover
®
ignition button pushes the igniter (button) down, and
returns to the up position.
If the Crossover
®
ignition system still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site. Log
onto www.weber.com
®
.
(1)
(2)
SPIRIT E/SP-
210 & 310
REPLACING MAIN BURNERS
1) Your Weber
®
gas barbecue must be off and cool.
2) Turn gas off at source.
3) To remove control panel: take off the burner control knobs. Remove the screws
holding the control panel in place. Lift off the control panel.
4) Unhook the manifold bracket
(1)
and unscrew the two wing nuts
(2)
that hold the
manifold to the cooking box. Pull the manifold and valve assembly out of the burners
and carefully set it down.
5) Slide the burner assembly out from under the guide screw and washer
(1)
in the
corners of the cooking box.
6) Lift and twist the burner assembly slightly, to separate the crossover tube
(1)
from the
burners. Remove the burners from the cooking box.
7) To reinstall the burners, reverse 3) through 7).
CAUTION: The burner openings (1) must be positioned
properly over the valve orifi ces (2).
Check proper assembly before fastening manifold in place.
WARNING: After reinstalling the gas lines, they should be
leak checked with a soap and water solution before using
the barbecue. (See Step: “Check for gas leaks.”)
(2)
(1)
1)
(2)
(2)
(1)
MAINTENANCE
