Weber mt 0170051, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 28

18
6. Transport
Lifting the machine The machine can be lifted for loading onto a vehicle.
CAUTION
Risk of material damage and injuries. The use of defective or
unsuitable lifting gear may cause the machine to fall down.
X
Use slings that possess the appropriate carrying capacity.
X
Fit the crane hook into the lifting ring and lift the machine up
straight.
Storage during transport Preferably transport the tamper in the upright position. If this is
not possible, the tamper must be laid on the side that houses
the exhaust. This is the only way to prevent any remaining fuel
from exiting the carburetor and fuel line and entering the air
filter.
7. Storage
Storage at the construction
site
If stored at the construction site, e.g. over night, the machine
must be secured against theft and unauthorized use.
Parked machines presenting an obstacle must be secured in
accordance with statutory regulations, particularly in the area
of public traffic surfaces.
Storage for an extended
period
If the machine will not be used for a period longer than one
month, the following measures must be taken:
X
Clean the entire machine thoroughly.
X
Check the entire machine for leaks. Correct any detected
defects.
X
Empty fuel and fill the tank with clean fuel.
X
Check and, if necessary, correct the engine oil level.
X
Check and clean air and fuel filter. Replace if damaged.
X
Lightly oil all bare parts, levers and accelerator control
cables.
If the machine is to be stored for longer than six months, contact the Weber
MT’s service organization to discuss additional measures.
Switching off the engine
X
Allow the engine to cool down at idle speed for a few
minutes (“min” position).
X
To switch the machine off, set the gas lever to the “0 / OFF”
position.
9
The engine is switched off.