Weber mt 0170051, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 28

16
Working with the machine
Starting the engine
WARNING
Danger of suffocation from engine exhausts when starting the
engine in closed rooms or poorly ventilated work areas.
X
Start the engine only in well-ventilated environments.
X
See section “Safety” for operating the machine in trenches.
ATTENTION
Risk of engine damage caused by insufficient lubrication after
horizontal transport.
X
Following horizontal transport, set up the machine vertically
and wait several minutes until the engine oil has collected in
the lower area of the crankcase.
X
Start the engine as described.
ATTENTION
Risk of engine damage. The use of starter spray may lead to
overheating in the combustion chamber.
X
Do not use any starter spray.
X
Bring the gas lever into the full-throttle position (I / ON).
X
Close the choke lever (1) (position A).
X
Press the primer pump (2) multiple times until the fuel feed
pipe is filled with gasoline.
X
Slowly pull the handle of the reversing starter until
resistance (the compression of the engine) is noticeable.
X
Allow the handle to glide back into the initial position.
CAUTION! The tamper may tip over when the reversing
starter is pulled. There is a crushing hazard.
X
Hold on firmly to the tamper while starting it.
X
Pull the handle through quickly, forcefully and completely.
X
Repeat the process if the engine does not start.
CAUTION! As soon as it starts running, the engine will
increase the speed. There is a risk of injury as the tamper
is started at full throttle and may perform unexpected
movements.
X
Set the gas lever to idle speed immediately after the engine
has started to run.
X
Allow the engine to warm up for a few minutes. Next, open
the choke lever (position B).