weasy SW45, Инструкция по эксплуатации

Страница: 8 / 75

3. Leave about 10cm (4inch) of thread on upper bobbin (Fig.3).
4. Raise the presser foot; hold the upper thread with the left hand, use right hand to
turn the hand wheel anticlockwise until the needle is raised (Fig.4).
5. When needle reach the bottom, the hook tray will hook the upper thread, ratate
the hoof tray to pull the lower thread out (Fig.5).
6. Pull the lower thread and upper thread under presser foot, pull out 10cm to the
back (Fig.6).
Caution:
It is essential that both top and bottom are threaded correctly.
Check carefully and do a practice stitch before begin to sew.
Very Important:
Make sure you always use a metal bobbin otherwise the magnetized bobbin
case will not be activated and there will not be any tension on your bobbin
thread.
WINDING THE BOBBIN
1. Put a spool of thread on spool pin (Fig.7).
2. Guide the thread through the upper of the thread clamper. (Fig.8).
3. Put the Push the bobbin into the bobbin winder spindle, and make sure it aligns with
the groove of the bobbin winder spindle. (Fig. 9).
4. Turn the winding spindle clockwise to make winding in clockwise way. (Fig.10).
5. Push bobbin to the right (Fig.11).
6. Open the speed switch to start winding. (Fig.12).
7. Stop winding after correct volume of thread is winded on bobbin. (Fig.13).
8. Take bobbin off the spindle and cut the thread. (Fig.14).
Note: Please use your hand to assist winding the bobbin. While the bobbin
winding, forbid there is thread on the machine needle, and then take up lever.