weasy SW45, Инструкция по эксплуатации

Страница: 9 / 75

NEEDLE REPLACEMENT
1. Turn the hand wheel to raise the needle to its highest position.
2. Hold the old needles and loosen the needle clamp screw. Remove the old needle
and discard responsibly.
3. Insert the new needle into the clamp with the flat side toward the right. Be sure to
push the needle clamp before tightening the needle clamp screw.
4. Tighten the needle clamp screw.
CAUTION: Remove the batteries and/or disconnect the AC/DC adapter before
starting to replace the needle.
SEWING SEWING
1. Turn the hand wheel on the side of the sewing machine anticlockwise to raise the
needle to its highest position. (Fig. 17).
2. Lift the presser foot and place the fabric you wish to sew under the presser foot
(Fig.18).
3. Lower the presser foot (Fig.19).
4. Press the ON/OFF button on the “ON” position and begin sewing. Do not pull the
fabric. Gently guide the fabric to keep the seam straight. (Fig.20).
5. After finishing sewing, press the ON/OFF button to the “OFF” position to stop
sewing. (Fig.20).
6. Turn the hand wheel to raise the needle to the highest position. Lift the presser
foot and pull out the thread tension release bar then gently remove the fabric away