WDS 1710 Series, Техническое руководство

Страница: 15 / 62

Only use the 1710/2 710/4710/9710radi
05-3305A01, Rev. E 7
4. Measure and install the primary power for the radio. The red wire on
the provided power cable is the positive lead; the black is negative.
o transceivers in nega-
tive-ground systems.
Connection to a positive-ground system or an accidental reversal
of the power leads can damage the transceiver.
5. Set the radio configuration. In most cases, the transceiver requires
only minimal software configuration. The selections that must be
made for new installations are:
•
Transmit frequency (
“
TX [xxx.xxxx]
”
on Page 31)
•
Receive frequency (
“
RX [xxx.xxxx]
”
on Page 29)
The operating frequencies are not set at the factory unless they were
specified at the time of order. Determine the transmit and receive
frequencies to be used, and follow the steps below to program them.
6. Connect a hand-held terminal (or PC) to the DIAG (diagnostic) con-
nector. When the HHT beeps, press to receive the ready
“
>
”
prompt.
7. Set the operating frequencies using the
TX xxx.xxxx
(transmit) and
RX
xxx.xxxx
(receive) commands.
Press after each command. After programming, the HHT
reads
PROGRAMMED OK
to indicate successful entry.
2.2 Transceiver Mounting
NOTE: To prevent moisture from entering the radio, do not mount the
radio with the cable connectors pointing up. Also, dress all
cables to prevent moisture from running along the cables and
into the radio.
Figure 5 shows the mounting dimensions of the transceiver.
ÝßËÌ×ÑÒ
POSSIBLE
EQUIPMENT
DAMAGE
ENTER
ENTER