Removing Modules from Network
15
Use the following procedure to
remove Z-Wave
®
modules from
your Z-Wave
®
network.
Houseport
®
can either be in
Design
or
Control
operation. For
this section on network setup
make sure that Houseport
®
is
set for
Design
operation.
Design
operation is indicated when the
window is outlined in a yellow and
black construction tape border.
1. Click on the Remove Module
button in the tool bar. A message
window will ask you to press the
button on the module to remove.
2. Press-and-release the PRogRAM
button on the Z-Wave
®
module. If
successful, a message window will
appear stating that the device has
been successfully removed. Repeat
this procedure if a message window
states that the module failed to be
removed.
NoTe:
Please see the User Manual
or Instruction Manual for the specific
Z-Wave
®
module being programmed
to locate the PRogRAM button
and for specific programming
information.
NoTe:
The process of removing
modules from a network is often
referred to as eXCLUSIoN.
NoTe
: You can also reset modules
in other networks using the ReMoVe
DeVICe button. If the target module
is part of another network, it will
be reset to a state which can be
included into a network, instead of
being removed from your network.
Please note that some modules
do not support being reset in this
manner and this procedure will fail;
in such cases, refer to the module’s
documentation for manual reset
instructions.
Common Operations
ON/O
FF
P
RO
G./D
IM
Press-and-Release
PRogRAM button on
module
