830873-0001 REV 02/20/2023
©Copyright 2023 Wayne Dalton, a division of Overhead Door Corporation
12
9”
(4) #8 x 1/2” Phillips
Pan Head Screws
Bottom Bar Angle
Bottom Bar
Assembly
Sensing Edge
Wireless Converter
Sensing Edge
Wireless Module
9. INSTALL CURTAIN
See Figure 18
• The Sling Method is recommended because rolling the curtain onto the barrel
assembly from the floor can cause curtain damage.
• Suspend the curtain below the barrel on two or more slings or ropes rated for the
weight of the curtain, shown on the “DATA SHEET”.
• Fasten the top slat to sling/rope and rotate the sling/rope to bring the top slat into
position.
• The top slat will have slots to attach to barrel. Hook curtain over studs and fasten with
5/16" round head screws and washers and TWO clamp washers provided.
See Figure 19.
• Coil curtain completely onto barrel using chain hoist.
WARNING
Rapidly closing curtain could result in death or serious injury. Use slings/ropes and locking
pliers on both guides to keep curtain in the open position until spring tension is applied to
the barrel assembly.
10. INSTALL SENSING EDGE MODULE
See Figure 20
• Install the sensing edge wireless modules onto the bottom bar angle using #8 x
1/2” Phillips Pan Head Screws. Refer to provided install manual inside of wireless
module kit.
Figure 18
Weld Stud
45:
9”
45:
1/2” Flat Washer
Two Clamp
Washers
Required
1/2” x 1” Hex
Head Bolt
Figure 20
Headplate
NOT shown
for clarity
Figure 19
Final Door Install
