Pico
™
on-the-go car seat
INSTRUCTION MANUAL
45
FABRIC PAD REMOVAL AND INSTALLATION
WARNING
• NEVER use your Pico without ALL fabric pads in place.
• Pay careful attention to how fabric pads are attached during
removal to allow correct assembly.
HEADREST FABRIC PAD REMOVAL
Adjust headrest to a convenient
location above the seat back.
Pull the bottom edge of the headrest fabric
down over headrest frame, then forward
and up around until it can be released
from the retention hook at the top of
the headrest adjustment post.
Locate and release the two snaps
on the inside bottom of the seat back.
Lift bottom of seat back to access fabric
fastener straps for top of seat back.
Release the fabric fastener at the top of the seat
back and in the strap at the center of the seat back.
Pull fabric over top of seat back frame and remove from frame.
HEADREST FABRIC PAD INSTALLATION
Reverse the removal procedure to install the headrest pad.
SEAT BACK FABRIC PAD INSTALLATION
Reverse the removal procedure to install the seat back pad.
SEAT BACK FABRIC PAD REMOVAL
With the seat bottom secured in the stored
position raise the headrest all the way up.
44
WARNING
•
NEVER use this car seat without the rigid
back panel in the headrest. This panel may
be spot cleaned with warm water and a mild
detergent, not laundered.
Check out support videos at
www.wayb.com/pages/support.
Point your smartphone’s camera
directly at the QR Code to activate.
