Pico
™
on-the-go car seat
INSTRUCTION MANUAL
15
14
Vehicle seat belts with locking latch plates normally hold a car
seat tightly. However, in some cases the locking latch plate on
some seat belts may slip and loosen after being buckled on a car
seat if positioned at a certain angle. If this happens, flip the latch
plate over and re-buckle. Test installation again to see if this
works. If not, move car seat to another seating location.
Manually adjustable lap belts normally will hold a car
seat tightly. In some cases, the locking latch plate on
some seat belts may slip and loosen if positioned
at a certain angle. If this happens, flip latch
plate over and re-buckle.
COMBINATION LAP & SHOULDER BELT WITH LOCKING LATCH PLATE
MANUALLY ADJUSTABLE LAP BELTS
NOTE:
If the belt pulls out, the retractor is an emergency locking
retractor which can be used to install car seat but MUST
be used with a belt shortening clip.
LAP BELTS WITH RETRACTOR
Flip
Flip
Lap belts with retractors may or may not hold a car seat securely.
Gently pull the lap belt out until it stops.
Gently let the lap belt retract about 6 in. (15 mm).
Pull back out on the lap belt.
If the lap belt is locked and does not pull out, then
you have a switchable or automatic retractor which
can be used with this car seat.
Retractor MUST always be switched to locking mode
when tightening vehicle belt to secure Pico.
Vehicle seat belts located forward of seat bight
may not securely hold car seat. Check vehicle
owner’s manual or see vehicle dealer for car
seat installation requirements.
BELTS FORWARD OF SEAT BIGHT
